The waste toner bottle inside edge where the toner sensor looks needs to be cleaned and the toner sensor itself needs to be cleaned. The top neck of the toner bottle usually has 2 round indentations that you can wipe clean on the inside and out. The sensor looks there for toner and triggers the code. The sensors are optical sensors that always reminded me of contact lenses. Look in the cavity where the neck of the bottle sits and clean the sensor and reflector on each side. And... as everyone else has said clear the error in service mode.
I may be wrong but the 7105 doesn't use that system. Large bottle in rear. if it overfills you will get an error. To prevent this the machine will give a message to empty waste toner every 250000 pages. There is a microswitch at the end of waste pipe assembly that will trigger when the pipe backs up. the waste pipe needs to be checked for a blockage.
I may be wrong but the 7105 doesn't use that system. Large bottle in rear. if it overfills you will get an error. To prevent this the machine will give a message to empty waste toner every 250000 pages. There is a microswitch at the end of waste pipe assembly that will trigger when the pipe backs up. the waste pipe needs to be checked for a blockage.
Yeah no sensors on this machine. Uses a microswitch with a torque limiter. You say auger is turning ok now....should be able to go to COPIER/COUNTER/MISC......highlight waste count,hit clear button to reset to zeros......
Yeah no sensors on this machine. Uses a microswitch with a torque limiter. You say auger is turning ok now....should be able to go to COPIER/COUNTER/MISC......highlight waste count,hit clear button to reset to zeros......
Bookmarks