What does this error code mean E000070/0101 and E000070/0201 on the canon Imagepress C1??? Thank´s.
------------------' E070 = Error in detecting ITB HP sensor-
xx=01: ITB home position sensor B, xx=02: ITB home position sensor A; only at ITB 1/1 speed; XX=00: no distinction 01xx = The period of time between when the home position of the ITB is detected and the next home position is detected is shorter than specified (-5% of standard duration). (884 msec or less)
Turn off the main power, check the drive of ITB, and then, turn on the main power 02xx = The period of time between when the home position of the ITB is detected and the next home position is detected is longer than specified (+5% of standard duration). (939 msec or more)
Turn off the main power, and check to see if there is any scratch on the surface of the ITB; then, turn on the main power.
--Check PS2 (ITB Home Position Sensor B) in I/O Mode, DCON Address P002 bit 9, to confirm the patch is being read.
If the patch is not being read check the PS2 wire harness from the DC Controller (J1193A pin 15 to J3401A pin 2 on the Side Driver PCB and J3403 pin 2 on the Side Driver PCB to frame connector J251L pin 2). Clean sensor PS2 or replace it if the wire harness and connectors check good.
If the patch is being read check the ITB Assembly and ITB drive for slippage.
Check if the Primary Transfer Pressure Lever is engaged.
The above picture shows the Primary Transfer Lever in the engaged position.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**