IR3200

[sniper2g8]

I have changed the ITB cleaning blade but I still have dirt when I print out. I suspect the black drum unit which is leaking how do I go about it? pls I need help. Thanks in advance

[gcsbkk]

I have changed the ITB cleaning blade but I still have dirt when I print out. I suspect the black drum unit which is leaking how do I go about it? pls I need help. Thanks in advance

The exact model is IRC3200

Can you show the picture how dirt but if you suspect with black drum > try to change it or clean the drum unit.

Good luck

[teckat]

I have changed the ITB cleaning blade but I still have dirt when I print out. I suspect the black drum unit which is leaking how do I go about it? pls I need help. Thanks in advance

----------------------------- did u remove all drums + toners + ITB unit + cleaning blade

then look inside printer toward the rail where cleaning blade slides into

( note--make sure to also slide out fuser ) there is probably waste toner sitting along that rail --- it's gets messy -unless u vacuum -lay paper down inside the bottom of printer & over that secondary transfer-- u can wipe with a damp cloth to clean-


also when u have out the ITB --REMOVE the metal plates and clean them off/ u will probably see toner on them (inspect both sides )