checked out this error code said it was a communication problem from power supply to mainboard. Should i just start replacing boards or is there a possible easier less expensive fix. would appreciate any advice ty
checked out this error code said it was a communication problem from power supply to mainboard. Should i just start replacing boards or is there a possible easier less expensive fix. would appreciate any advice ty
Does this machine have an internal (S1) Finisher?
If so, remove the finisher and check the wiring from HV PSU to Main Controller. The yellow cable sometimes becomes trapped behind the finisher during the installation process, causing E191 errors.
It can also be a pinched wire from j404 on the HVPCB to J4001 on the rear frame. But Dan is probably right, I've done that myself.
Like the United States Postal Service It's a miracle it works!
Bookmarks