CANON IR2270 ALWAYS JAMS

[mramlawi]

Dear all ,
i have a canon ir2270 and its jams too much the Jam code is 0107 as i saw the figure they putted its jamin on PS13 (which means its the fixing sensor) but i wonder it looks ok .the paper always jams some time under the Drum ,and some times at the 2nd delivery tray .

is theirs any solution for this , i also tried to change the bypass door also the 2nd inner delivery and i changed the pick up feed unit for the 1st cassette and still the same problem always jams .

thanks

[ernesto]

HI
If It jam in doble side mode....

I think the problem is the paper humidity....in a4r it'll work
...in a4 you should update firmware and adjust in service mode .... I am going to send you by mail when I can.

All the best

[cdanger]

Dear all ,
i have a canon ir2270 and its jams too much the Jam code is 0107 as i saw the figure they putted its jamin on PS13 (which means its the fixing sensor) but i wonder it looks ok .the paper always jams some time under the Drum ,and some times at the 2nd delivery tray .

is theirs any solution for this , i also tried to change the bypass door also the 2nd inner delivery and i changed the pick up feed unit for the 1st cassette and still the same problem always jams .

thanks

Hi

Check the registration sensor for a worn tip. I had one recently where replacement of the sensor flag (FL2-4520) resolved the problem.

Regards,
Charles

[canonbundy]

Hi

Check the registration sensor for a worn tip. I had one recently where replacement of the sensor flag (FL2-4520) resolved the problem.

Regards,
Charles

Or cut a piece of mylar/thin plastic & stick to Flag - quick & cheap.

Maybe replace Fixing Assy - Fixing Film grease may be gummy & not allowing the sleeve to rotate fast enough - check for E007 errors.

[ernesto]

HI

ir 4570 jam 0105

All the best

[northernlife]

0107, bad ps13 - Can you trip it in service mode part check and verify functionality?
worn reg sensor flag
Vertical path rollers are they grey or black?
there's a mod for the door that came out after this was released to get rid of that foam crap that some schmuck thought would be a good idea.

All I have in my own files for this code.

[Brian8506]

Also check if pre reg flag sticks. The other end rests against a rubber damper pad that gets old and sticky and can prevent paper from getting past the flag. There are a bunch of those on the guides on the door too that cause these problems.

[mramlawi]

HI
If It jam in doble side mode....

I think the problem is the paper humidity....in a4r it'll work
...in a4 you should update firmware and adjust in service mode .... I am going to send you by mail when I can.

All the best

Thanks alots Ernesto the problems solved on 2 machines as you sent me the mail i followed the steps and no more jams at all


regards