Have replaced drums, transfer belt, auto-grad, fuser. Still has blurred copies, prints, etc.
Anyone found a solution for this or had this happen before?
Thanks
Have replaced drums, transfer belt, auto-grad, fuser. Still has blurred copies, prints, etc.
Anyone found a solution for this or had this happen before?
Thanks
===========================================
iRC5185 came out in y2007, blur copies & prints have been an issue since then-there have been numerous pubs posted here from Canon.
1-u did not say if issue is in Main Scan or Sub-Scan(paper feed) direction ? or a combo of both directions ?
2-did u check>clean or replace the SALT SENSOR UNIT ?
3-did u set LASERS to home position ? ( in service mode or manually)
iRC5180_Color_Shift_Prevention _&_Correction.pdf
what does the PG6 GRID test print show ?
sub scan.jpgMAIN SCAN.JPGSALT SENSOR.JPG
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks