E000355-001

**Age102** · 09-17-2014

Hi Folks
Just fitted main controller taken off IRC2380i in working order fitted to IRC3080i part numbers are the same Machine is booting up now although slowly then errors E000355-001.
Does anybody know if you have to swap any original pcb's ie memory pcb ect onto the replacment Main controller.
Any help would be good.

**teckat** · 09-17-2014

Originally Posted by Age102

Hi Folks
Just fitted main controller taken off IRC2380i in working order fitted to IRC3080i part numbers are the same Machine is booting up now although slowly then errors E000355-001.
Does anybody know if you have to swap any original pcb's ie memory pcb ect onto the replacment Main controller.
Any help would be good.

================================================== ================================================== ==

If you remove the Main Controller PCB for repair by an Authorized Parts Repair Facility (A.P.R.F.), ensure
the Counter Memory PCB has been removed and remains with the engine. After installing a new or repaired Main Controller PCB, ensure the optional counters 2 through 6 (displayed in “Counter Check”) are restored to the original end user requirements in service mode: OPTION>USER>COUNTER 2 ~ 6.

E355=
Mismatch of serial numbers of three items: ECO ID PCB, Main Controller PCB (SRAM) and Counter Memory PCB.
1. Put back all original PCBs into the equipment!
2. Do not utilize a used Counter Memory PCB or ECO ID PCB from any other equipment.
3. Ensure connector J1213 is connected.
4. After “Prohibited Action” has been corrected, perform “E355 CLR”.
(FUNCTION>CLEAR> E355-CLR) then cycle power off and on.

Press Additional Functions button then #2&8 together> then Additional Functions button
then again>Additional Functions button then 1&9 together> then #3 (brings u into LEVEL3)
COPIER>FUNCTION>CLEAR>E355-CLR
Turn OFF and then ON the equipment.

The Counter Memory PCB, ECO ID PCB and SRAM PCB retain information pertinent to the specific engine they are installed in.

SRAM is mounted onto the Main Controller PCB. in this Series

Ensure that you never swap any of these circuit boards with another engine.
If any of these circuit boards are swapped, it can result negatively in equipment performance.

E245, E246, E247, E354 and E355

DO NOT CHANGE TWO OR MORE BOARDS AT ANY ONE TIME. THIS CAN RESULT IN THE EQUIPMENT ENTERING AN ERROR CODE LOOP. ONCE THIS OCCURS, YOU MUST CONTACT THE CANON TECHNICAL SUPPORT CENTER FOR ASSISTANCE.