A3 a.jpgA3 b.jpg
Hi, Please
I have a problem in Irc3220, only appears in a A3 paper size only and weight 90 g/m, view attachment arquive, i "Turn the adjusting screw [1] at the
front/rear so that the length of the pressure" and did not effect, fusing roller upper, lower and bearings is changing.
Thanks
Last edited by cesarkazu; 09-19-2014 at 09:13 PM.
Originally Posted by cesarkazu
hi ,
did you checked the ITB if theres a spots on it cos looks like ITB problem
Distinguished road makes you jewel in rough
yes, i check the ITB, seemed like everything was normal, this defect appears in A3 paper size only.
COPIER>FUNCTION>FIXING>NIPCHK
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Sorry, i am beginner
COPIER>FUNCTION>FIXING>NIPCHK
nip.jpghow to measure it?
------------------------------------------------------------
see attach/ u need to slide out sorter & cheat it's switch to run nip check
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
already do this, the problem is that the image is not in the center like figure F06-402-02------------------------------------------------------------
see attach/ u need to slide out sorter & cheat it's switch to run nip check
------
That is only an example
U are only going to measure the crossover shiny patch) (front to back of test print)
If patch is to wide on ends-u get poor fixing on ends.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
it looks as if you are doing 100 % coverage on 90gsm? Try doing the same from the bypass using 100gsm or heavier and setting to heavy 1, this slows the fixing down to fuse into the media properly.
Good point on heavy stock,
But u can not run full bleed 100% coverage on this model with any success, with these crap fix units
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Posting Permissions
Thanks: 
Likes: 
Dislikes: 
Reply With Quote
Bookmarks