-------------:-D
iR3200_TP03 174f.pdf (1.77 MB, 0 views)
Most important, did u remove the ITB drive gear unit & inspect the gears\ the helical gears (/////) wear down and walk over each other.
U need to remove to check, a peak in will not do.
The Swing Gear Assembly will now be called the
Swing Plate Unit, part number FM3-3775-000 and only one 42T gear [ FU7-0403-000] can be replaced.
The other gear is pressed in and cannot be replaced separately. If both gears are damaged a new Swing Plate Unit must be replaced. If only the driving
42T gear [FU7-0403-000] is damaged it can alone be replaced.
SWING UNIT_iR3200.JPGSWING UNIT-PIC_iR3200.JPG
>
You may need to replace the Pattern Reader Assembly\ solved many registration issues , when all other procedures were tried.
>After aligning all Laser Assemblies it may be necessary to initiate a fine adjust to achieve proper alignment. To do this start with the Black Laser Assembly.
Move the alignment gear one tooth at a time and then let the machine perform a registration adjustment. Usually, you will have to perform this fine adjustment a few times until the registration is close enough for the machine to correct it automatically.
>Did u record the laser #numbers from their top label into service mode_?
>Check the connections to the DC Controller. The Laser connectors are dove tail type. If the dove tails are not positioned in the groove, the connection to the DC Controller may be poor. Reseat the connector by pressing the dove tails into the grooves while inserting the connector.
How old is ITB SHEET_?\ they strech over time*
Bookmarks