service mode advance 9200 series

[roho]

I saw there is a service mode setting copier>option>dsply-sw>t-lw-lvl for adjusting a warning for low toner. I went to one of these models, and that service mode isn't there, level 1 or level2. How can this be adjusted without this mode? I have noticdd the 5000 series advanced has this, however it was a 9200 series manula that I found it listed in. Any suggestions or work around? A couple of customers want earlier notification of low toner status. Thanks!

[teckat]

I saw there is a service mode setting copier>option>dsply-sw>t-lw-lvl for adjusting a warning for low toner. I went to one of these models, and that service mode isn't there, level 1 or level2. How can this be adjusted without this mode? I have noticdd the 5000 series advanced has this, however it was a 9200 series manula that I found it listed in. Any suggestions or work around? A couple of customers want earlier notification of low toner status. Thanks!

===============================================
You can set the machine to display a message indicating that the remaining toner is low.
This message is useful because it gives a user plenty of time to check their toner stock, and ensure the availability of replacement toner.

For imageRUNNER ADVANCE

1) Select Settings/Registration on the copier's display.

2) Select [Login].

3) Enter the System Manager's ID as well as the System Pin.

4) Select [Preferences].

5) Select [Display Settings].

6) Select [Display Remaining Toner Error Message].

4) Select [On] or [Off].

5) Press [OK].




or
it's there

COPIER > OPTION > DSPLY-SW

TNR-WARN ON/OFF of toner warning display

-Level.1 Details To set ON/OFF of toner warning display.
-Use case When preferring to hide the alarm until the toner runs out

-Adj/set/operate method
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 1
0: Display, 1: Hide
Default value 1
Related service mode COPIER> OPTION> DSPLY-SW> T-LW-LVL

Timing to display the Toner Container preparation message:

COPIER>OPTION> DSPLY-SW > T-LW-LVL (Level2) 5% to 100%