Originally Posted by
teckat
E100
It is indicated if the BD signal is not detected within a specific period of time after the laser has been turned on.
E100
Main Cause =The BD PCB is faulty. The laser unit is faulty. The laser driver PCB is faulty. The wiring is faulty (short circuit, open circuit). The DC controller
PCB is faulty.
0001 = In 100 msec after the laser drive signal has been generated, the BD signal is not detected 50 times or more within 40 msecs.
0002 = While the laser is on, the BD signal cycle is found to be outside a specific range 10 times or more.
BD PCB
1) Try replacing the BD PCB. Is the problem corrected?
YES: End.
Laser output
2) Try replacing the laser unit. Is the problem corrected?
YES: End.
Laser scanner unit, DC controller PCB
3) Try replacing the laser unit. Is the problem corrected?
YES: End.
NO: Check the wiring; if normal, replace the DC controller PCB.
Bookmarks