Originally Posted by
teckat
**********:-D There is an option called 'Long Strip Original' that will automatically rotate the scanned originals during the scanning process.
The Long Strip Original option will only be visible in the Special Features tab of the Copy screen when the following service mode is executed:
In Service Mode Level-2:
Enter service mode by pressing the additional function {*} key followed by the 2 & 8 key together, then additional function {*} key again
COPIER > OPTION > USER > MF-LG-ST
Sets long length mode key.
0: Normal setting
1: Display long length key in mode screen
Default factory is set to 0
Once the MF-LG-ST is set to 1, the Long Strip Original option will be available in the Special Features tab of the Copy screen.
*********
To enable the 'Long Strip Original' option, follow these steps:
1. On the copier control panel, select the Send tab.
2. Pull down the 'Scan Settings' drop down menu and select 'Option'.
3. Press the 'Document Size Select' button on the resulting Scan Settings screen.
4. Press the 'Long Strip Original' button. The size will automatically switch to 'Auto'. The feature is enabled when the option is highlighted in blue.
5. Press 'Done'.
6. Press 'OK'.
7. Select your destination and send the job by pressing the Start key.
8. The resulting image will be automatically rotated.
* Note - Be sure to load your originals with the bottom short edge going into the feeder .
If you load your originals the other way, the resulting image will be portrait but upside down.
Bookmarks