Jams on 300gsm - 010c, 010d

[V-P]

I am getting a lot of jams (010d, 010c) while feeding 300 gsm paper through multidrawer A1 into a irac9060.

I have cleaned all rollers in the paper path and cleaned all the sensors.

I have replaced all (pickup, feed, sep. rollers) on the multi-deck A1.

If I use 200 gsm paper or lower gramature - the feeding process goes smooth.

Is it too much to ask to run 300 gsm ? or I need to change all the rollers in the paper path ?

Machine has done approx. 1 milion A4.

[zoraldinho]

I had the sam problem on our brand new ira 9060 with 300gsm paper. With this kind of paper I was forced to use our old clc5150.

[V-P]

no shit...

The book says - 300gsm

[Rachid.Akli]

no shit...

The book says - 300gsm

Hi to all,

i think that the book says 300 gsm with the manual bypass. With the multidrawer deck A1, it is limited to 220 gsm only. In the Image Press C700/800, which uses the same muli-drawer option, if you need to use the 300 gsm paper, you need to add the manaul bypass as an option.

Rachid.

[zoraldinho]

Yes, Rachid is right! 52 to 220 g/m2

[V-P]

From the service manual of the multi drawer (page 11):

This equipment can feed coated/thick and handle 52 to 300 g/m2 media.

[zoraldinho]

I believe you but check Canon product spec:


http://www.usa.canon.com/CUSA/assets..._Only_rev1.pdf

[V-P]

On the multi-drawer it says: 52-300 gsm

[zoraldinho]

Capture.jpg

[V-P]

Those specs are for paper deck NOT multi drawer