Hello all,
After about 2 months without using it, my copier is not power on again.
What could be the problem ?
I need your help even if i could have a link to download the shematic diagram of all the PCB.
Rgds
Hello all,
After about 2 months without using it, my copier is not power on again.
What could be the problem ?
I need your help even if i could have a link to download the shematic diagram of all the PCB.
Rgds
Check the power cord to make sure it is secure where it goes into the back of the machine. Also, maybe make sure the outlet the machine is plugged into is providing the correct amount of voltage.
Unfortunately, it has been years since I've worked on Canon equipment, so if that doesn't work I'm completely out of ideas.
Good luck.
================================================== =======
Power supply rating 120/230 V
When the main power switch (SW1) is turned on, AC power is supplied to the low-voltage power supply circuit in the power supply PCB.
The low-voltage power supply circuit supplies +3.3 V, +5 V, and +24 V to operate the machine.
+24 V is supplied to the motors, fan, electromagnetic clutch, solenoid, etc. +5 V and +3.3 V are supplied to the sensor, etc.
There are two types of +24 V voltages: +24 V which is normally supplied from the low voltage power supply and +24 VR which is cut off when the front cover or the left door is opened. The +24 VR also plays the role of a door open detection signal (DOPEN). This signal allows the CPU to detect that the front cover or the
left door has opened.
Power supply PCB = Generates DC power from AC power.
Option power supply PCB (option) = Generates DC power from AC power for the options.
Main power switch (SW1)= Supplies AC power to the power supply PCB.
Front cover switch (SW2) = Detects opening/closing of the front cover and cuts off +24 VR.
Left door switch (SW3)= Detects opening/closing of the left door and cuts off +24 VR.
Protective Mechanisms
The power supply PCB is provided with an overcurrnet/over-voltage protection function to automatically cut off the output voltage when a trouble such as a short
circuit occurs on in the load.
When the overcurrnet/over-voltage protection function is activated, turn off the main power switch, solve the trouble with the load, and then turn on the main power
switch.
Further, the power supply circuit has two fuses which blow to stop power supply when an excessive current flows in the AC line.
================================================== ================================================== ==================
The machine possesses 2 power switches: main power switch and control power switch. Normally (i.e., unless the machine is in a sleep state), the machine will be
supplied with power when you turn on its main power switch.
check if Front Cover or Left DOOR SWITCH is functioning
like posted>
u need to check AC OUTLET> then check if printer is outputting the AC> Then check your DC input/output
- Check whether the power cord is plugged in the outlet securely.
- Check whether the specified AC voltage is applied to the outlet.
- Check whether all outer covers are attached.
- Check whether the main power switch and the power switch on the operation pane are turned on.
- Check whether no fuse on PCBs is blown.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Can someone provide me with the power supply PCB's shematic diagram ?
Thanks a lot Teckat !!!!
God bless you
Hello all,
The circuit diagram i received from Teckat is unusable; I need the electric shematic diagram of the power supply PCB to allow me check the electronic components and voltage. Thank you in advance.
Rgds
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks