Thanks: 0
Likes: 0
Dislikes: 0
I need your support how I can get my copier start
printing from computer. Currently, I can connect using serial port but the
copier receive print job and shows "Receiving Data" but doesn't print.
Briefly:
-iR3300(iR2200)
-Boot-ROM VERSION 10.29C
-RAM 128MB
Awaits
Thanks
================================================== ======Originally Posted by Olara2015
1. Clear Sector 1 found in service mode.
Enter service mode select COPIER>FUNCTION>SYSTEM>CHK-TYPE>select 1 and press O.K.
Next select HD-CLEAR and select O.K. The machine should display 50% then O.K! The machine will clear sector 1 which is the image storage area.
This will only clear the image control data stored on the SRAM. Sometimes there can be files or images that can backup the storage area and cause this problem.
2. Remove>clean ends>Re-seat the SRAM on the Main Controller. (or try replacing the SRAM (memory).
last resort>>>>>>>>>>>>>>
3. Reformat and reload system software.
Try each step and then test the machine before going to the next step to see if that particular step resolves the problem.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Hi
The Printer(iR3300/2200) is displaying "5002: Printer Processing" whenever I send a job from the pc.
As I can't reformat as I don't have the system software or any link?
------------------------------------------------------------------------------------------------------------------------------------
Did u try THE FIRST TWO procedures I posted ??????????????
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Re: 5002: Printer Processing
Yet yo try second procedure when am back at office tomorrow but tried the first one no change yet.
Thanks
Posting Permissions
Reply With Quote
Bookmarks