********
Could be a Defective Size Detection Assy. { FM2-3319-000 }
Is the lead edge of the copy varying by a half of inch during copying ?.
--Have u inspected \ changed registration flag,
--Registration Sensor Actuator spring was tightened by adding a wrap_?
--Did u replace the
Registration Clutch_?
"'Paper is not correct.
Change paper.'" is displayed when copying from the Glass or the Feeder.
Workaround :
This error message can be caused by a
broken or misaligned Position Block (shown below, Figure 310/312 in the Parts Catalog). If the cassette does not seem to be locking into place, this part may be the cause. In some cases, applying pressure to the front of the cassette will temporarily alleviate the problem.
Position Block -
FC6-4357-000
Other_?'s
?-1. What size paper is loaded in that tray
?-2. Does this message show on different sizes of loaded paper
?-3. Do u have a two or four tray set up
?-4. What happens when\if u change paper after message
Bookmarks