Originally Posted by
madas
Hi guys
I hope someone can help on this, I accidentally broke the ribbon cable connector on the laser unit, pulled it off the board no less.
I have access to one from another m/c but am unsure of any changes to settings. Not much luck in the service manual, have any of you swapped the units from m/c's without any original paper work for the values of settings to be changed?
Heres hoping.
madas
PS
just had a thought that if the m/c I'm going to take it out of is running I should be able to get the settings there? But it might not be a complete m/c.
Bookmarks