Bizhub fax issue

[christian09]

Interesting problem...bizhub223...everything great except fax Rx's only receive 1page of multiple page faxes,from multiple numbers, and tested ricogfax just fine.
Thanks

[copydocinc]

Unplug power cord, after turning machine off. Plug back in, try again. I know this is elementary, but the best of us have forgotten to do the basics form time to time

[christian09]

Thanks doc. Already tried it.

[allan]

Do you think its a bad line?
Or that fax configuration is wrong.

[copier tech]

Do you think its a bad line?
Or that fax configuration is wrong.

I agree this is most likely a bad line, plug in a handset & make a call, listen for crackles etc

[christian09]

Thank you for helping. Dumb question, but how do we test for a bad line?
I have a hard time overcoming a customer that says "why is it working on my Ricoh fax?"

[allan]

You can connect a handset and listen for crackling sounds and any abnormality.

Is the machine connected to PSTN or PABX?

[allan]

I agree this is most likely a bad line, plug in a handset & make a call, listen for crackles etc

Sorry missed you post there

Ok go to the job log and get the code that pops up there under detail. that could help, does the machine give a failure message or a NG delivery report.

Did you check the marketing area?
Did you reinitialize the fax?

What have you tried so far?

[christian09]

You can connect a handset and listen for crackling sounds and any abnormality.

Is the machine connected to PSTN or PABX?

Hi there.
Checked the line....clear
Set for pb.
Tried: ecm off,slowed to9600,reinitialize fax,next step is new fax board.
It s quite odd, sometimes it prints 1 page of a multipage, other times nothing. Yesterday I sent 3 pages OK, then nothing...no real pattern. When you mention marketing area, I recall like a353 set to Japanese. And it caused odd fax issues. Will check this.
Thanks again.

[Iowatech]

For what it is worth, it appears that there are a lot of people with Bizhub experience here:
http://www.copytechnet.com/forums/konica-minolta/
You might try posting there too.