Originally Posted by
slimy
Hey everyone,
So I was making a small edition of 150 yesterday and half way through, my machine gave me an error of A06-403 and it just kept thinking the sensor was off. I'm guessing my tray unaligned itself and went too low for the sensor etc but long story short, it took about 3 hours of taking the paper tray, sensor, etc apart to fix.
After fixing that, another problem came up that wasn't an issue before, (No error codes anymore though) when i try to make a master, whether it's through the scanning bed or through my laptop (i have a nic card) it reads as if i'm making something smaller. I've attached some pictures. The original images are supposed to be 8.5x11. I've replaced the paper tray with one I know is working, I've replaced my logic board, I've reseated all my cables, I've gone to test mode to factory reset, nothing seems to work. Note: It's not that the rest of the drums aren't inking up, the machine itself thinks the master is that small so it's burning masters that size even though the files/scanning bed images are both 8.5x11
Any help or suggestion? My technician thinks it's electrical but I'm hoping it's some easy fix that I haven't thought of yet?
Re: rz220 problems with master being made
Hi!!, I have this partial printing problem. You were able to fix it sometime? I saw the 1102-1103 codes, and I tried but I don't quite get it. Just hnowing that this problem can be fixing in that way is a hope for me. If not I will have to find another way. Thank you!!
Bookmarks