I received a T11 error and saw that the gear for the print pressure adjustment gear was sitting just
below the pressure control motor gear so just spinning constantly until it times out and errors out.
It is pictured here:
IMG_2232.jpg
At first I tried to adjust the standard pressure position via the pressure control sensor bracket as instructed in the tech manual. However, I could not get the gear teeth in to position with the pressure control motor gear.
I removed the pressure control motor and was able to get the gear teeth in sync again and tighten everything securely. However, I am unsure how this error even occurred? Did it go out of adjustment or slip somehow? Any input or advice is greatly appreciated.
Bookmarks