I do not seem to get the 24 volts to the magnetic clutch on the axis of the clutch. It is controlled by a sensor?
(Translated by google)
I do not seem to get the 24 volts to the magnetic clutch on the axis of the clutch. It is controlled by a sensor?
(Translated by google)
adjust the stack switch in the paper feed unit. it is behind the green dials where you put the paper in. It will cut power to the clutch.
I already tried this, but does not work. It seems no power to the magnet that the two impulses to withdraw the paper. The shaft of the clutch is not spinning.
(Google translation)
How did you resolve this issue? I have the exact same problem.
Never mind, I fixed it!
Bookmarks