Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 5 of 5
  1. #1
    Technician
    Join Date
    Jul 2010
    Posts
    11
    Rep Power
    28

    Riso RZ 370ep wont ink drum after fixing p-04-513 error.

    I had a p-04-513 error (ink overflow) i read how to fix it,
    took the drum apart and cleaned off the shorter wire, removed ink etc.

    This resolved the error message, my first 100 prints after this worked fine
    but then it all began to fade like the ink was running out,
    it now does not seem to be inking the drum although it makes all relevant noises,
    I have tried several masters, a new ink and inking it in test mode (0887)

    if anyone can help it would be much appreciated...
    thanks
    Elliott

  2. #2
    Trusted Tech 50+ Posts djdan73's Avatar
    Join Date
    Oct 2008
    Location
    moundsville wv
    Posts
    64
    Rep Power
    32

    Re: Riso RZ 370ep wont ink drum after fixing p-04-513 error.

    you may have ink built up on the longer wire on the drum pcb inside the drum check it because it sounds like it thinks it has ink in it so its not adding any

  3. #3
    Technician
    Join Date
    Jul 2010
    Posts
    11
    Rep Power
    28

    Re: Riso RZ 370ep wont ink drum after fixing p-04-513 error.

    This was the problem, thanks a lot!

  4. #4
    Trusted Tech 50+ Posts djdan73's Avatar
    Join Date
    Oct 2008
    Location
    moundsville wv
    Posts
    64
    Rep Power
    32

    Re: Riso RZ 370ep wont ink drum after fixing p-04-513 error.

    no problem glad i could help

  5. #5
    Trusted Tech 50+ Posts ukyo's Avatar
    Join Date
    Aug 2008
    Posts
    51
    Rep Power
    32

    Re: Riso RZ 370ep wont ink drum after fixing p-04-513 error.

    If that error will appear & bother you again, double check the squeegee drive gear (Gear;m1x25x8.5 OWC) beside the squeegee idle gear & located at the end of the squeegee roller.That's in the rear side of the drum. You have to remove the Rear Drum Frame so that you could see the drive gear.That gear should turn 1-way in clockwise direction.If you can turn it the other way around, remove the gear & clean it thoroughly especially the bearings on its center part.If not replace it.That "damned" gear is the main reason why the ink will build up on the drum pcb coz the squeegee roller doesn't turn at all & also the bloody mess in your hands.Hehehe..
    Hope this will help..

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here