Hello everyone, my RP3700 shows me T03-522, and i have no idea of how to fixt it.
Hello everyone, my RP3700 shows me T03-522, and i have no idea of how to fixt it.
There is no T03-522 for the rp3700. There is a T01-522, which is position B sensor does not go ON/OFF while the main motor is operating.
If you remove the rear cover, move the pcbs, you will see a sensor on the support plate/frame for the drive, about the middle of the frame. Unscrew the sensor plate and blow out the sensor. Reattach sensor plate and pcbs. Good luck.
hi, sorry, it's code t03-502
It's a clamp sensor error. (on top of the drum, holds the master). Make sure the magnet A on the rear of the drum is not loose. Could be a problem with the clamp motor or solenoid, too.
NEVER ASSUME ANYTHING
Sorry Mikadonoran, but the RP clamp ass`y does not have a magnet on. Thats on the GR. The RP uses a motor with two photo- interrupts and a half moon disk. It is located behind the pcbs at the top of the unit. Either the sensors are dirty or the motor/gears are broken or the clamp itself is damaged.
Bookmarks