Thanks:
0
Likes:
0
Dislikes:
0
-
Trusted Tech
50+ Posts
- Rep Power
- 32
Riso GR3750 Image Adjustment?
My Risg GR3750 has an issue.
Every master I make on Any cylinder I use the image prints more than 1 inch to the right of the lead edge. There's not enough range in the "print position" button to compensate for that discrepency.
How do I determine if it's the cylinder alignment, timing or scanner that is out of sync?
Thank you,
Dana
-
Re: Riso GR3750 Image Adjustment?
Get a manual and check the timing in the back. There are holes and cut outs that need to line up 1st. Then there is a procedure for adjusting the registration. These may have been listed in a previous thread or two on how to.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks