C21, load master error.
To reset machine: turn off, hold reset button down, turn on while still holding reset for 3-5 seconds.
Good luck.
C21, load master error.
To reset machine: turn off, hold reset button down, turn on while still holding reset for 3-5 seconds.
Good luck.
Good morning,
I did a full reset and then tried to make a copy & it still misfed.
Thanks again for your input - gdh
Probably the allen screw for the gear that drives the write roller has backed out. Or possibly the load roller, might as well check both while in there. They are the two rubberish black rollers located in the master making area.
Like 20gaugeo/u said.
The hex screw on the write roller drive gear has come loose. It was a common problem on this series check the gear and the belt has to have the proper tension if not the master will fail to load proprely it is the pulley G in the picture attached. Hope it helps.
Last edited by LA TECH; 08-01-2014 at 11:06 PM.
Bookmarks