this machine required the ink system be replaced. I replaced it and had an issue priming it. When the priming was finished and the message pops up to ask if the heads have ink in them, neither choice was highlighted. I used the up and down arrow button and nothing changed. Also the message was opposite as shown in the manual. the choice for no ink was on top. Not knowing what else to do, I pushed OK hoping it would highlight a choice. It took the top selection, no ink, and wanted me to do it again. I found another set of heads and did it again. Got same result with message. This time when I pushed the arrow down and up, I may have touched the OK, not sure, but I am back in same position. I need to get past this step, the ink is fine. Is there any way to boot this machine so it will come up normal. If not, can the set up heads be used again? In other words, will it blow them out and leave me with a mess, or does it have to do with pressure and not hurt anything?
Bookmarks