Originally Posted by
Wild Bill
59.00.20 or 59.00.30
Feed motor (M101) failure (start-up or rotational)
Reconnect the connector (J191) on the feed motor and the connector (J91) on the DC controller PCA.
Use the feed motor (M101) drive test in the Component test to verify that the motor is properly functioning. If is not, replace the feed motor (M101).
I don't think its the drum motor, if you continue getting this...59.00.30 error. the DC Controller, would have been my guess.
Try a Pre-Boot Firmware upgrade. Use the Clean Disk item in the Preboot menu. Reload the firmware.
I wander if the service manual is wrong? Let us know what fixes it.
Bookmarks