I am having a problem with Tray 2 not lifting. Its not seeing the papertray.
I am having a problem with Tray 2 not lifting. Its not seeing the papertray.
I had one "Out Of The Box" Doing that.
Facing the printer, left side paper guide, that has the size sensors was out of position. The screw from the factory was loose so it popped out . I popped it back in, Tightened the screw and that fixed it.
The paper lift motor won't rise if the actuators don't get made.
Izzy
You are not talking about the paper tray right? When you say the right paper guide? I switch paper trays and it did the same thing.
Ye LOL Left side.
The side where the sensors are...
Izzy
I had an m608 with a "Tray 2 overfilled or roller issue" after replacing the Tray 2 feed and sep roller ass'ys. The problem was that I failed to lift the aqua-colored tab on the feed ass'y from the horizontal position upward approximately 30º until it latched.
DOH!
...Lorenzo
Bookmarks