Dislikes:
0
-
Technician
- Rep Power
- 0
Z3200 ps 44-in will not boot up
Current problem is this: Turn the power on and the machine starts booting like its supposed to. Once the count-up hits 17% it just sits there.
History: a month ago the belt shredded, up until then it worked without a problem. I replaced the belt and tensioner assembly. Had the customer replace "bad printheads". Started getting 86:01 codes after that. I never could get it to pass the scan axis or carriage calibrations. But it did print excellent color documents and internal images.
So a week after delivering it back to the customer it will not boot past 17%.
any ideas?
-
Technician
- Rep Power
- 12
Re: Z3200 ps 44-in will not boot up
Maybe just bootup in "Diagnostic Mode" and do an Unsecure ERASE to wipe the drive and have it reinstall firmware.
-
Re: Z3200 ps 44-in will not boot up
Remove the roll and all printheads and power cycle the plotter. Install the printheads when asked. Had a similar issue and this fixed it. It could be a faulty printhead.
-
Re: Z3200 ps 44-in will not boot up
I agree with Lance; remove the print heads, and the ink cartridges.. see if it powers up.. then install the supplies again.
If you're having 86:01 errors, check the encoder strip for damage. Clean it if you haven't already.
Kiran
-
Re: Z3200 ps 44-in will not boot up
And don't forget that spacer.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks