Dislikes:
0
-
Re: Color laserjet pro MFP M477 59.F0 error
-
Junior Member
- Rep Power
- 0
Re: Color laserjet pro MFP M477 59.F0 error
I Just had an M452dn that would throw error 59.F0 every 2 or 3 prints.
The belt looked to be fine. I removed the belt and inspected it, put it back in. Re seated connectors, checked sensor flag. Same result.
Next, I installed the latest firmware. Now, when I start the printer the error comes up while it's warming up- can't even get a print out.
I ordered a new transfer belt assembly and that took care of it. I have tested it for hours and no code. I was reluctant to spend the money on the transfer belt after reading all of the posts about causes other than the transfer belt assembly itself.
By the way, the printer has 73,000 total prints.
-
Re: Color laserjet pro MFP M477 59.F0 error
If you have a few of these out, do yourself a favor and go to your wholesaler and get a few HP M 452(cheaper), transfer belt, fuser and main pcb, and other parts are the same. Can get cheap. The 59.0 error is the transfer belt. have taken one apart, they are not made to be taken apart. Literally have at least 40-50 parts that just fall apart when taken it apart, LOL!!! Belts look like new, but internally there are sensors, a solenoid that does not like to get dirty, and multiple gears, actuators and cams, all for the belt to function. Easy replacement procedure though, once you do a few, 15-20 minute job. Good Luck.
p.s. Hp has a firmware update to "fix 59.0 error" Doesnt do nothing, still have the error. Common problem with those models.
-
Technician
- Rep Power
- 7
Re: Color laserjet pro MFP M477 59.F0 error
Hello!
I found a solution for my printer here:
https://youtu.be/7lFF1Wh8Tmk
Good luck!
-
Technician
- Rep Power
- 7
Re: Color laserjet pro MFP M477 59.F0 error
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks