Thanks: 0
Likes: 0
Dislikes: 0
I am working on a 4200 that the tray will not lift on. I replaced the lift motor and it still will not work. It plugs into the DC controller so that would be my next thing to replace, however since I can't return the DC controller if I buy it, I was wondering if someone else has had this problem.
The greatest enemy of knowledge isn't ignorance, it is the illusion of knowledge. Stephen Hawking
You guessed rite. That is the board. Had one of these. motor was cheap but not the problem.
Have you install another tray and see if it worked?
Yes I swapped trays first. I just did not want to find out there was some magic reset I did not know about, I have had a lot of firmware issues lately on HP. Thanks for the replies.
The greatest enemy of knowledge isn't ignorance, it is the illusion of knowledge. Stephen Hawking
I also believe you are on the right path... been awhile, but I think I had one of these also a long time ago. A init wouldn't hurt, but I don't think that helps with mech failures on HP's all that much. Let us know how you make out.
The glass maybe half full, but less is more...
Printer + Fax + Copier = Jack Of Many Trades,
but Master Of None
Color Copier = Not A Color Printer
InkJet MFP = Not A Fax Machine
B/W Copier = Not A Press
Finisher = Deal Closer (salesman, not accessory)
Copier Tech = Admin's Stress Ball (Scapegoat)
Reply With Quote
Bookmarks