I have been to look at the above printer and am getting light copies/prints
the copies/prints don't seem to have much density any ideas ?
The pm kit was replaced 70k ago and the toner has done 15% of its life (had problem before this was changed)
I have been to look at the above printer and am getting light copies/prints
the copies/prints don't seem to have much density any ideas ?
The pm kit was replaced 70k ago and the toner has done 15% of its life (had problem before this was changed)
I assume this is when printing from menus not when making a copy from the ADF:
1. Make sure economode is not on.
2. Clean all cartridge contacts.
3. (90% chance this is your problem) Remove laser scanner, hold up to light and with a lint free swab clean mirrors and lenses. Do not use cleaners. Be gentle. Dirty mirrors or lenses can make print light.
4. Change cartridge.
After that the only other things it could be are HVPS and DC controller.
Life should NOT be a journey to the grave with the intention of arriving safely in an attractive and well-preserved body, but rather to skid in sideways - Coke in one hand - chocolate in the other - body thoroughly used up, totally worn out and screaming "WOO-HOO, what a ride!".
This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from
Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
I usually find that the user has been messing with the default darkness setting.
The darkness adjustment goes from Zero to 8. Most people think that the higher the number the darker the print, it's actually the other way around with Zero being the darkest setting.
This has solved the problem pretty much every time
Bookmarks