Thanks:
0
Likes:
0
Dislikes:
0
-
-
Technician
- Rep Power
- 36
REMAN
http://www.scc-inc.com/engine/Engine...350_Remans.pdf
I normally dont remove the plastic welds on contact side I use flex method after removing the gear end plate, Flexing the contact side and lifting the drum up on an angle and away to release the axle
-
-
Technician
- Rep Power
- 36
You can also use summitlaser.com and user/password is: AO , on both lines!
futuregraphicsllc.com/techguides
In order to reset new chip is needed, will run without but lose supply status, low toner
Last edited by TonerTech; 09-28-2007 at 05:12 AM.
-
-
Technician
- Rep Power
- 36
Without new chip cart will function with the same memory and toner left on chip memory and will not be @ 100% and will still run when you enter continue. Just needs to be aware when you start to get light print
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks