HP Color LaserJet 1600 - Black Shade

[Smiley27]

If you could check these prints I made, what could possibly be cause of this? All toners are new...


SKMBT_C20312013110510_Page_1.jpgSKMBT_C20312013110510_Page_2.jpg

[groovy]

I'm sure that issue is due to a defective black toner cartridge, most probably the waste toner container is full, the drum is worn, the doctor blade is broken...

[Smiley27]

Hmm, but its bough new, that bothers me ... Could black drum get defected by staying for 2 days in wet room with low temperature?

I'm sure that issue is due to a defective black toner cartridge, most probably the waste toner container is full, the drum is worn, the doctor blade is broken...

[groovy]

If it's bought new, just return it to your salesman....

[Smiley27]

Look what I did:

Found old black toner ( 6000 K ) - it had like 7%, after turning machine on, it did cleaning/calibration, copy was fine...

Then put back ''new'' one that made that dirty copy - turned machine on, it did cleaning/calibration, after that,copy is fine ...

... So I guess it was calibration, because I did cleaning for 30 or more times...


Thanks.

If it's bought new, just return it to your salesman....

[groovy]

Listen to me, your new toner cartridge has a problem.

[BAAKLINIELIAS]

HELLO
move up for 0.5 mm the doctor blade it will be lightly and the shadow go

[jcontractor]

I'm sure that issue is due to a defective black toner cartridge, most probably the waste toner container is full, the drum is worn, the doctor blade is broken...

Question: This printer have waste toner?
I have a HP Colorlaserjet with problems in the printout, the TBU is full of lines and toner, I didn't saw the waste toner or TBU cleaning blade, How it clean the TBU?

[groovy]

Question: This printer have waste toner?
I have a HP Colorlaserjet with problems in the printout, the TBU is full of lines and toner, I didn't saw the waste toner or TBU cleaning blade, How it clean the TBU?

This printer has a waste toner container for each cartridge, located into the cartridges.
I think you must proceed this way:

1. if you are a tech: open every cartridge and wipe out the water box container (only trained personal with adeguate equipement can do this);
1. if you are NOT a tech: change toner cartridges

2. wipe out the ETB with a soft, lint-free dust remover dumped with isoprophylic alcohol.

[jcontractor]

This printer has a waste toner container for each cartridge, located into the cartridges.
I think you must proceed this way:

1. if you are a tech: open every cartridge and wipe out the water box container (only trained personal with adeguate equipement can do this);
1. if you are NOT a tech: change toner cartridges

2. wipe out the ETB with a soft, lint-free dust remover dumped with isoprophylic alcohol.

Thanks a lot for your comment, really appreciated.