HP Laserjet 4730 replace Fuser & Image transfer

[khoacoitnt]

Hello you, I have a hp laserjet 4730 printer error fuser and transfer belt to be replaced. no way to give this notice to be no. please help me, I thank many

[JustManuals]

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads

Paul@justmanuals.com

[fixthecopier]

Sorry, on that one you have to put those parts in.

[Wild Bill]

This might work for transfer kit
Same type of reset with a fusable link that blows when you install it.

Metrofuser’s Flash-It™ Restores Life to HP 4700 Transfer Kits
New Tool extends the life of the 4700 transfer belt and maximizes consumables.

[ignacio.cortez]

Hello you, I have a hp laserjet 4730 printer error fuser and transfer belt to be replaced. no way to give this notice to be no. please help me, I thank many

If Fuser Error, Fuser needs to be replaced, I'd reset the Fuser Counter (Maintenance Kit) at the same time.

Transfer Belt, there might be a counter you can reset on the service mode, but as the other post stated, there might be a fuse that needs to pop for the counter to reset.

It's worth a try, if you have a SERVICE menu try this number 09473005 as the Service password, it worked on one of the ones I had to service, but not on another one. Give that a try, or Google the password for the model

[Imagnet_Tech]

This might work for transfer kit
Same type of reset with a fusable link that blows when you install it.

Metrofuser’s Flash-It™ Restores Life to HP 4700 Transfer Kits
New Tool extends the life of the 4700 transfer belt and maximizes consumables.

How much does the Flash-It cost? I have been to the website, and read about it, yet no where does it have a cost for it.

Thanks

[good]

Sorry to hear that but you will need to replace your fuser and image transfer kit to fix your problem.

[Igotkeys]

Hello you, I have a hp laserjet 4730 printer error fuser and transfer belt to be replaced. no way to give this notice to be no. please help me, I thank many

Vrai simple'ment! Both the fuser and the transfer belt are fuse loaded. On the ETB, I just removed the two screws housing the motor cage. Find there a "clipped on" .25W 30Ohm "fireproof" metal film resistor. The fuse blows to reset count. The fuser is resetable the same way. Can't tell you right now in front of me the resistor value. Cheers!

[d7guitar]

Take out the fuse, put in a staple, install fuser or transfer assembly with the power on. As soon as you shut the door the device will reboot. Immediately remove the staple. Reboot again. Counter is cleared. I've done this with fuser and transfer assembly. Both times I smelled an "electronic " smell but no harm done toy devices. Please use at your own risk.