Dear ya'll..i'm kind'a stuck with Hp laserjet 9065mfp,Error code is SC36-o1.can anyone gimme hint what is it?don't even have a service manual.
tried to google it but no luck yet!!
Dear ya'll..i'm kind'a stuck with Hp laserjet 9065mfp,Error code is SC36-o1.can anyone gimme hint what is it?don't even have a service manual.
tried to google it but no luck yet!!
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
http://www.justmanuals.com
Paul@justmanuals.com
If you're working on that machine, trust me, BUY a manual. Paul's really good a bout hooking you up with one. These machines should not be played with if you don't have one. It's not your average HP.
Life should NOT be a journey to the grave with the intention of arriving safely in an attractive and well-preserved body, but rather to skid in sideways - Coke in one hand - chocolate in the other - body thoroughly used up, totally worn out and screaming "WOO-HOO, what a ride!".
I agree totally
Izzy
Me too. The best $12.77 you'll ever spend. And it's on sale this month for $10.77
Just Manuals
hello.. it's fuser problems
you need to go to 25 mode and set the SW switch 3-01 to off or on. the problems will go if it keep coming need to clean or change one of the TH.
have a try error code as per the manuel below.
F36-01*
TH1 (fuser temperature /1) has not reached50° C when the specified time has passed since
the fuser on control has been processed after
secondary power switch (SW2) is turned on.
PRCB (printer control board)
DCPS (DC power supply
unit)
L2 (fuser heater lamp/1)
L3 (fuser heater lamp/2)
TH1 (fuser temperature /1)
TH2 (fuser temperature /2)
When F-34-∗∗, F35-∗∗ or
F-36∗∗(fuser temperature
related abnormality) occurs,
be sure to repair a defective
part before setting the 25
DIPSW 3-1 to 0. If the 25
DIPSW 3-1 is set to 0
without repairing a defective
part, this may cause a fire.
* DIPSW 3-1 must be reset
to 0 (unlatched) to clear the
error code.
Bookmarks