Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 5 of 5
  1. #1
    Technician 500+ Posts
    Join Date
    Sep 2011
    Posts
    827
    Rep Power
    24

    Color LJ 2600 Registration issue

    Got one that has the color registration off. Calibrated and still has same problem. Talked to someone and they said sometimes it takes a few calibrations to get it right. They also said you can reset the DC Controller by opening front door>hold down engine test button> turn on>close door>release engine test button after 10 seconds. Another suggestion was to clean the sensors.

    Looks like the black is ok, just the colors are off. Thought I would throw this out there and see what anyone thought of the suggestions I've been given, or if anyone had additional input that may be helpful. All cartridges are above 50% except yellow which is at 12%. Total count is 33572.


  2. #2
    Service Manager 10,000+ Posts
    Color LJ 2600 Registration issue

    JustManuals's Avatar
    Join Date
    Jan 2006
    Location
    Las Vegas, NV
    Posts
    10,041
    Rep Power
    140

    Lightbulb Re: Color LJ 2600 Registration issue

    This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


    http://www.justmanuals.com


    paul@justmanuals.com


  3. #3
    Technician
    Join Date
    Nov 2013
    Location
    London
    Posts
    26
    Rep Power
    9

    Re: Color LJ 2600 Registration issue

    Whats the condition life of the transfer belt...?
    are the density / calibration sensors clean.

    If you open the printer while its showing and running calibartion do you see the toner image
    on the belt ok and does it look aligned and correct.

    sometimes the transfer belt and plastic holder can become twisted or off straight.
    does it lock up tight and straight.

    you could try running the secondary Service menu.

    At ready press green button, then press left arrow and orange cancel at the same time.
    then press check button again.

    run all / full calibration and check.

    Elliot


  4. #4
    Technician 500+ Posts
    Join Date
    Sep 2011
    Posts
    827
    Rep Power
    24

    Re: Color LJ 2600 Registration issue

    Thanks Elliotsmonstor. I went back this morning. Tried a few more calibrations. Then calibrated all in secondary. Made sure sensors were clean. Laser is clean. Even tried reset by opening door>power on while holding down engine test button for about 10 seconds> closed door, then calibrated. Still no go. There was another 2600 there with new cartridges in it. Took those cartridges and put them in the problem machine and the print were great. Put the original cartridges back in the problem machine and all is great. Go figure. Did learn a little more about the machine though. Thanks again.


  5. #5
    Technician
    Join Date
    Nov 2013
    Location
    London
    Posts
    26
    Rep Power
    9

    Re: Color LJ 2600 Registration issue

    Good to hear its kind of fixed...

    Could simply be that one or more of the units was not 100% sitting correctly, locked in.
    or as said the transfer belt and plastic holder was closed straight by you that time and is now printing ok.

    anyway for now all is good.

    ATB

    Elliot


Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here