konicaminolta bh 700"ready to accept another job:

**montana** · 06-20-2015

hi gentlemen...i have bizhub 700 which was serviced and stored for along period about one year ago..when i turned the machine on and it is warmed up and ready to copy.i tried to make copy.it is scanned the documents by the document feeder and it is displayed the message "ready to accept another job"and stay there no copying...is there any thing wrong?...please help me......thanks...

**allan** · 06-21-2015

Do a demo page print after restarting the machine. Goto utility user settings and the printer settings. See if that prints.
Does the engine keep run?
These machine aslo do that if there is a fault or jam in the finisher. Remove the finisher and test.
If the machine was sitting its a good idea to run cartridge install mode in service mode.

**montana** · 06-21-2015

Originally Posted by allan

Do a demo page print after restarting the machine. Goto utility user settings and the printer settings. See if that prints.
Does the engine keep run?
These machine aslo do that if there is a fault or jam in the finisher. Remove the finisher and test.
If the machine was sitting its a good idea to run cartridge install mode in service mode.

thanks my dear...but the machine unable to print demo page...it is only giving "ready to accept another job"after scan...so it does scan but no printing out...

**allan** · 06-21-2015

My dear, Really

.

Check the memory used.
Re-seat the ram and connectors.
Format HHD.

Some ideas.

**copier addict** · 06-22-2015

Are the jobs sitting in the job list or are they being deleted?

**emujo** · 06-22-2015

Did it have a key counter attached to it before it went into storage? From your description, it looks like the jobs are being "held". Emujo

**montana** · 06-30-2015

Originally Posted by emujo

Did it have a key counter attached to it before it went into storage? From your description, it looks like the jobs are being "held". Emujo

hi...the amazing thing there is a three machines in the store with the same issue...???is there any wrong with the storage conditions?...thanks

**allan** · 03-15-2017

Originally Posted by captainrva

Sorry to resurrect this thread but I just had the same issue with a customer where the copy jobs would go through the document feeder but then just sit in the job list. Would not print demo page either. I logged into the web browser and saw the Imaging Units said End Life so I went into service mode and set them to "Not Stop" and then everything worked again.

Is that a BH700?? don't think so.