Konica 1050 sc49-01

**copycorner** · 06-30-2015

I have an SC49-01 pointing to the HDD2. I replaced the hard drive but the submenu for formatting all is not highlighted so I can't format the new drive. Am I missing something?

**Mick01** · 07-01-2015

Hi,
You say you replaced the HDD. What with (brand new brought from a shop or one brought through KM)
The reason I ask this is the HDD has been formatted into seperate partitions so a store brought drive will not work.
The only way to do this if you buy a store bought is to clone an image from a good original HDD.

Hope this helps

**copycorner** · 07-01-2015

Yeah, I got a used seagate drive from the computer store across the street. Then I realized, after going through the manual, that they are preformated. Now I'll have to go to KM in the morning to see how much a drive is going to cost. I did format the drive through the service mode after all but the "Store" and "Recall" buttons don't light up on the touch screen panel. Any reason that you can think of for that. Almost like an failed part isolation is on but I don't know where it could be. Any input?

**allan** · 07-01-2015

did the code go away after that format?

**copycorner** · 07-01-2015

Yes, the code is gone but I can't recall any jobs or store any jobs because the recall and store button won't light up. It's like the HDD is not there or it has been turned off somehow.

**Risu** · 07-23-2015

Hi, I bought hdd clone docking station just few weeks ago.
I was starting to clone all printers hdd's yesterday, but ques what.
I started 1050 and 49-01!
Looks that the hdd is gone. Windows XP can't open/check the hdd, but isn't that normal because of it is not windows software on hdd?

Starting to search firmware disk image to download and a new hdd...
And starting to find ide-pata hdd converter for clone station also...

**itan84** · 02-24-2016

Hi,
I have a sc 49-01 code at the second time on the machine in last 2 years . This time it's going to sc in few days after developer change , I thing it's something wrong with adjustments . I remove the IC board and clean it inside from dust,then recall a factory initial data/HV adjustments/and adjustments after developer change.
Then controller starts properly , after receiving many files about few hours printing its crashes and SC error again . When I do LD offset adjustment do not coincides with test pattern no5 after do all adjustments for developer and I wonder why?

**mariappanpm** · 07-07-2017

Did you get back that Store and recall functions Lid ON???

then what was the solution???

**itan84** · 07-07-2017

Hi,
The reason for this was the burned-out heating lamp. After the replacement, the controller started to turn on. The print quality was caused by not cleaning the laser dustpan while replacing the drum and developer. Evidently there is not enough toner in the developer, I changed the switches to make more toner, but once it prints perfectly and once there is a problem with the black color.