c454e Print Jobs Locking up machine

[splblazer91]

This is a 3 week old machine. It has K6 firmware. It seems as if the machine locks up coming out of sleep mode when it receives a print job. I have turned off sleep mode but it seems to still go into a low power state according to the customer and is still locking up. Any Suggestions?

[EarthKmTech]

disable weekly timer
disable power consumption during sleep mode.
you have already disabled sleep mode - these 3 are what usually fixes this for us.

[splblazer91]

Ive disabled all those to no avail so far. FYI it locks up on any document (pdf,ppt or word)

[EarthKmTech]

is it crashing in sleep mode, ie never waking up in the morning?

if yuve done all of this and its still doing this every morning you may need to replace the SSD - we have had to do that in the past too. For us we tried a new mfp board first and it made no difference, the ssd fixed it.

is it logging any error codes ?

If its got lots of FA17's, it could be being caused by something else on the network - in which case none of the above will make any difference. Have had this too.

[splblazer91]

It does wake up when the job is sent but never prints. Data light just flashes til you cycle power then it prints.

SSD is a possibility. It has had one FA17 Code.

Network isnt an issue i dont think. I have about 95 machines on this same network that work fine.

[EarthKmTech]

It does wake up when the job is sent but never prints. Data light just flashes til you cycle power then it prints.

SSD is a possibility. It has had one FA17 Code.

Network isnt an issue i dont think. I have about 95 machines on this same network that work fine.

Rule out the network - where i had the fa17 issue and machines locking every machine onsite was doing it.

[splblazer91]

Replaced SSD Board then MFP and all is right again in the world.

[MVPunisher]

Yep I had to do the SSD board also. Did a "self diagnostic" in service mode and one part of the SSD showed NG.

Replaced SSD never heard from them again. Much easier than mfp.

[fishleg]

How did people fix the fa17 if it was due to network? We had a battle with a customer almost being sued because of 4 machine all locking up within a few mins of each other. Would love to know how you fixed it or what caused it?

We actually took a new machine and said watch, it crashed in front of customer who just said well all my xerox machines work... Which they did to be fair so we took a samsung and a kyocera but only the Konica's would crash... 20 plus calls with even Konica being baffled. We replaced the whole machine, fw, disabled every network service nothing would work but if you left the network unplugged machine would be happy all day long. In the end the calls stopped so they obviously was something on there network which was crashing our machines but they wont tell us as we would kindly hand them one huge bill....

Sent from my D6603 using Tapatalk

[copier tech]

I've never needed to replace a SSD Is there any specific procudure for replacing the SSD or is it simply a case of fitting the part, any special firmware etc?