Thanks: 
Likes: 
Dislikes: There is a sticky actuator damper in the exit section on the machine, remove the small sponge pad.
Remove the side cover and the exit section 5 screws and a connector look for the sensor and see if it sticks.
There is a sticky actuator damper in the exit section on the machine, remove the small sponge pad.
Remove the side cover and the exit section 5 screws and a connector look for the sensor and see if it sticks.
Whatever
Go service mode....system 2....u will find Dip sw sett
Originally Posted by antone
Seriously!? Are you for real? Trying to get your post count up for some reason?
Started in the copier service business in the fall of 1988 and worked at the same company for 33.5 years, becoming the senior tech in 2004 but left to pursue another career on 4/29/22.
Back on machine. Has no hole punch. Did disconecting fs-925 finisher problem goes away. Can't find any thing causing this...
Check the jam code under counter in service mode.
Whatever
In service mode counts jams as jams...at #3206 fixer/fuser
Change out PS37 on the main body and PS1 on the finisher. Check that PS37 actuator falls back easily.
Whatever
looking for the part #'s of both asap..may need the parts catalog if someone wants to share or trade for one
GRRR! What happen to the post showing a link to the parts catalog?
Use State Conformation do the sensor check. Have you removed the side cover on the machine?
Whatever
Posting Permissions
Reply With Quote
Bookmarks