bizhub C284 Display flickers when moved back and forth

[Laserbeam]

Hallo to all!

The display of a bizhub C284 starts to flicker when you slide the panel.

The cause is known. It´s the ribbon cable from the upper to the lower board. Unfortunately, this cable is not available as a spare part. Only the complete panel for about 580 €.
I have made some detailed pictures of it. Maybe someone knows where this cable is available. The cable has 40 wires.

[Synthohol]

Konica has a 3 year bumper to bumper warranty, if you clear all the logs and change the install date in service mode the list output will "show" its less than 3 years in the field and the panel can be returned under warranty.
unless you are not working for an authorized dealer, but thats the downside to being an independent i guess.

[allan]

Konica has a 3 year bumper to bumper warranty, if you clear all the logs and change the install date in service mode the list output will "show" its less than 3 years in the field and the panel can be returned under warranty.
unless you are not working for an authorized dealer, but thats the downside to being an independent i guess.

Hehe

[habik]

Konica has a 3 year bumper to bumper warranty, if you clear all the logs and change the install date in service mode the list output will "show" its less than 3 years in the field and the panel can be returned under warranty.
unless you are not working for an authorized dealer, but thats the downside to being an independent i guess.

You can't clear some data like detailed code history.

[habik]

Hallo to all!

The display of a bizhub C284 starts to flicker when you slide the panel.

The cause is known. It´s the ribbon cable from the upper to the lower board. Unfortunately, this cable is not available as a spare part. Only the complete panel for about 580 €.
I have made some detailed pictures of it. Maybe someone knows where this cable is available. The cable has 40 wires.

Try computer/ laptop repair shop or ebay for LVDS 40 pin cable

[EarthKmTech]

It was once available as a replacement part internally, I recall receiving the email. I never had the problem so never had to change it. Its no longer a current machine so i suspect any chance of it being released as a spare part now are long gone.

[Synthohol]

go old school, use an ohm meter and test all 40 wires from terminal to terminal.

[habik]

... Or get a magnyfing glass and solder 1:1 with new wires.


Sent from my iDon't believe in marketing device using Tapatalk

[EarthKmTech]

Or,

just recover panels from machines returned for recycling.

[allan]

... Or get a magnyfing glass and solder 1:1 with new wires.


Sent from my iDon't believe in marketing device using Tapatalk

That is some serious skill.