blank prints on ineo + 454e normal copies !

[jakani]

hello,

the issue started last week and no one is able to print anything all the prints are blank ! i connected my laptop directly with the machine still the same BLANK ,

the copy is working just fine !

any suggestions on the cause or how to solve this problem

thank you very much

[allan]

Can the machine do internal prints like the counter pages or the demo page?

[jakani]

Can the machine do internal prints like the counter pages or the demo page?

hello
thanks for replying allan

yes it do the internal prints !

yesterday i changed the driver from PCL to Postscript and it start printing normally !

BUT the problem with the postscript is very slow on the network ,so the machine takes a long time to recieve and print a single job !
and there is 80 people printing on that machine

i have to change back to PCL driver ! but i have no idea why it prints blank prints


any suggestions would be appreciated

thank you

[imihm]

[QUOTE=jakani;525179]hello
thanks for replying allan

yes it do the internal prints !

yesterday i changed the driver from PCL to Postscript and it start printing normally !

BUT the problem with the postscript is very slow on the network ,so the machine takes a long time to recieve and print a single job !
and there is 80 people printing on that machine

i have to change back to PCL driver ! but i have no idea why it prints blank prints


any suggestions would be appreciate

thank you[/QUOTE


Hi There...
Since the internal print tests are ok...it is just driver issue go back to pcl and see...

Thanks

[allan]

Try using LPR instead of RAW on the port settings.
Could be a driver version problem.
Did you try updating the firmware?

[allan]

Is PCL error reporting on or off?

[jakani]

Try using LPR instead of RAW on the port settings.
Could be a driver version problem.
Did you try updating the firmware?

no i didn't try updating the firmware ! i will try i hope it helps

Is PCL error reporting on or off?

the machine doesn't show any error after it prints

[jakani]

Try using LPR instead of RAW on the port settings.
Could be a driver version problem.
Did you try updating the firmware?

i updated the firmware and that solves the problem


thank you