hi all,
IC 408 dose not connect to the pc,i have re installed the fiery software and also cleared the cmos but still fails to respond or connect. any help or suggestion will be appreciated.
hi all,
IC 408 dose not connect to the pc,i have re installed the fiery software and also cleared the cmos but still fails to respond or connect. any help or suggestion will be appreciated.
1) try for pinging
2) if not possible go through scan if you locate IP address
try pinging again
Try manually setting the IP address if you have not already...
When you connect the Ethernet cord are the leds on the port lighting up?
Are you using the correct network connector? I once reinstalled the system software on one just to find out that the customer had changed the cable from one port to the other...
' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!
' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!
one of the buttons on the panel will show the IP address.
there are 2 lan ports on the fiery, use the bottom one.
the scsi cable from fiery to the video interface, reseat it.
just some basic suggestions.
oh, what model copier? on the newer ones there are bit switches to change.
Bookmarks