Anyone having a solution for the cracked ADF hinge on a BH-C-25, other than getting a new part from KonicaMinolta for lots of $$$$'s?
Having three BH-C-25's and two MC-1690mf with that problem......
Hans
CrappyHinge20160924_105121.jpg
Anyone having a solution for the cracked ADF hinge on a BH-C-25, other than getting a new part from KonicaMinolta for lots of $$$$'s?
Having three BH-C-25's and two MC-1690mf with that problem......
Hans
CrappyHinge20160924_105121.jpg
" Sent from my Intel 80286 using MS-DOS 2.0 "
that hinge is under $40.00 US, best to just replace it and ask the user to be a little nicer to the feeder
A lot of the smaller Sharp DFs have the same condition. There's nothing to do but change the hinge. The manufacturer needs to ask themselves: "I wonder would would happen if I were to put really strong springs inside a plastic hinge assembly, and then worked it back and forth a few thousand times?" =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
But the computer said its OK...
Whatever
Also remember them to be priced around there if you are a KM dealer....
Whatever
The cheapest quote I got was 68.00 Euro = 75.00 USD........This hinge should be <10$
Hans
" Sent from my Intel 80286 using MS-DOS 2.0 "
Bookmarks