So you are saying only a board reset will fix the problem if i keep the firmware where its at?
So you are saying only a board reset will fix the problem if i keep the firmware where its at?
Whatever
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Ok .
Never done it before not a big board changer.
Makes sense a i would be wiping it.
I will then use 00-A9 to start with.
The board has been ordered so i am going to give the reset tool a try anyway.
Whatever
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Darn no luck...
Tools works just fine but the board seems to be the cause.
Anybody with the B range and the C754 tool?
Will replace the board tomorrow.
Whatever
Firmwares HERE.OK Google! ... will I need Berrocca this morning?
What i meant was B/W's.
A61FFW
A55VFW
My bad they are both for B/W.
Whatever
allan, do you need firmware?
Here's the C754 Tool: https://www.dropbox.com/s/jh313uwow7...145FW.TAR?dl=0
Bookmarks