-
Trusted Tech
50+ Posts
- Rep Power
- 7
konica minolta d351 install image unit
I have a big prblem with this copier dialta 351 display says install image unit no change, I put a fuse, and the copier is ready then I open the right door and close it ,install image unit is displaying again. thanks.
-
Senior Tech
100+ Posts
- Rep Power
- 5
"Install Image Unit" means the machine cannot detect the IU.
Take it out and clean the metallic contacts on the side frames.

Kenny

-
ALIEN OVERLORD
500+ Posts
- Rep Power
- 13
Go back to where you put in fuse, if you left it loose it may not be making contact.
-
Technician
- Rep Power
- 4
You will also want to make sure the fuse is of the proper rating. An over or under rated fuse will not clear the code properly. If it's an under rated fuse, you may need to replace the fuse again. Ohm out the fuse to make sure it hasn't blown already.
-
Senior Tech
100+ Posts
- Rep Power
- 5
Please note the title of the original poster.

Kenny

-
Trusted Tech
50+ Posts
- Rep Power
- 7
minolta di351
thanks for your answers but I can not solve it.I clean all contacts into machine and the imagen unit too.I want to know how the copier check the imagen unit, Any suggestion. I am sorry but I don write english very well I am from peru thanks
-
Senior Tech
100+ Posts
- Rep Power
- 5
Make sure the IU is properly installed. You should push the IU all the way into the copy machine.
What is the message shown on the screen? (Install Image Unit or Replace Image Unit) ?
I want to you to check it again. It is a big different.

Kenny

-
Trusted Tech
50+ Posts
- Rep Power
- 7
minolta di351
thanks for your help deep ,the message is install image unit , I pushed in it all the way. I can close the right door. The customer said me that the screen was displaying replace imagen unit,but the machine was copying. this week the copier was stopped and the message replace imagen unit was not blinking. He called a technician and he put the fuse and he didnt back.now I have this problem.
-
Senior Tech
100+ Posts
- Rep Power
- 5
You should notice that there are two components connected on the connector, one is what we call it a "fuse" (1/16 Ohm) for reseting the "Replace Image Unit" Message. The other is a resistor (~38 Kilo Ohm). Check this resistor with a multi-tester. Make sure it is good (Not open circuit). Also check the "golden contacts" on the connector are all good.
If the error persists, try it with a known good image unit. If the "Install Image Unit" Message is still there, there may be something burnt by putting the fuse incorrectly.

Kenny

-
Trusted Tech
50+ Posts
- Rep Power
- 7
minolta di351
thanks mr. deep where is the 38 kilo ohm resistor? I need solve this machine.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules
Bookmarks