From there is doing nothing again
Sent from my Infinix HOT 4 using Tapatalk
From there is doing nothing again
Sent from my Infinix HOT 4 using Tapatalk
We have only started to do the Konicas from C280 onwards so missed these
Easiest way to check if the fuser is registering as an old unit is by pressing utility and then consumable life. If it is empty then follow the below instructions.
If they are like the C280s models it should just be a case of entering the service mode, select counter, select life, press new release then open the front door and highlight fuser then click the print key whilst the door is open. Once youve done that close the door and exit service mode.
That will reset the Fuser count.
Try using the search option on this forum
lots of info on this topic
but if your too lazy to search
KM C253 Fuser unit reset
based on your posts so far i recommend you get a qualified tech to do this for you
even google search comes up with answer
Konica Minolta Service Manual: How to reset the fusing unit - Bizhub C203 / C253 / C353
Last edited by Elmo; 12-16-2016 at 03:37 PM.
I Used To Live To Fix Things Now i Fix Things To Live
Thanks all. I appreciate your efforts and time.
Sent from my Infinix HOT 4 using Tapatalk
Once you get that message you cant fit used units you need to fit a new fuser unit as they have a quick blow fuse.
You can however cut off the fuse & replace it with a glass 80mA rated or lower, simply solder it in.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Before you do anything else,check your icp's on the printer control board.
In the past i have had a c253 that didnt want to reset the transfer belt and found a blown icp.
Whawhawhahwa
Whatever
Darn! I missed out on a whole lot of confusion. I am so disappointed. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
hi
change the PRCB board i had the same prob with the transfert belt in diff machine ;
good luck
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Bookmarks