Top of main forum is a post new thread button.
Top of main forum is a post new thread button.
I am getting the same J20-02 jam code. The definition of this code is so ambiguous - it makes my head spin. Bz754 with 1.8 clicks. What did you guys find? Is it the soft gray transport rollers on the LCC just after the take up tires?
I saw somebody post that they replaced the spring on the separator roller with a lighter spring. I'm sure how that would work but I can try that.
I can't see it being anything on the machine side since Trays 1-2-3-4 do not jam.
Thanks
GC
take the cover off and measure the diameter of the outside of that grey roller compared to the middle.
you can adjust the loop timing to see if it helps in the short time.
good luck.
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
I was servicing Minolta before the merger and in their terminology LCT was a large capacity tray, which was the 2500 sheet tray that sat under the machine. The LCC was a large capacity cabinet, which was the 3000 sheet cabinet that sat beside the machine.
I know this doesn't help in solving the original poster's problem, but, it is kinda interesting how terms change.
I've had pc410 do this
Would jam on a c364 but Run fine on a c224
LCC, LCF, LCT ... tomato tomato ... not much difference.
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Bookmarks