bizhub 601 missing print on lower part of an 8-1/2x11 PIC INCLUDED

[Ad3t0]

Iv'e replaced the drum, drum blade, all the corona wires and cleaned out and replaced the developer and its MUCH better than before but now I see there's a little problem on each page towards the bottom where nothing will print. What part should be replaced or what can I do to solve this?


Thanks ahead of time for any help or input! Looks like an awesome community!

[Woxner]

replace the transfer corona assy. it is more then just the wires. look likes it dropping off

[Woxner]

forgot the screws on the guide will come loose and do this too. but if its an old assy replace it

[Ad3t0]

forgot the screws on the guide will come loose and do this too. but if its an old assy replace it

Thanks for the tip I'll be looking into it right away! I'll post back if it works out.

[Woxner]

hope that the side with the blanks has not damaged the drum.

[Ad3t0]

WORKING! It was the unit that holds the coronas there must have been something wrong with it thank you!!!